IAI America RCA2-SA6R - Manual (Page 70)

62
13. Maintenance Inspection
13.3 Cleaning
y Clean exterior surfaces as necessary.
y Use a soft cloth to wipe away dirt and buildup.
y Do not blow too hard with compressed air as it may cause dust to get in through the gaps.
y Do not use oil-based solvents as they can harm lacquered and painted surfaces.
y To remove severe buildup, wipe gently with a soft cloth soaked in a neutral detergent or alcohol.
13.4 Adjusting the Stainless Sheet
If the actuator stroke is 400 mm or more, check the stainless sheet for slacking, etc., as necessary. If the
stainless sheet is found slacked, adjust the stainless sheet.
[For the stainless sheet adjustment procedure, refer to 13.9, “Replacing/Adjusting the Stainless Sheet.”]