IAI America IX-INN8040H - Manual (Page 24)

18
2. External Dimensions
black
red yellow
white
IX-HNN-70
††H
Reference
surface
17.5 (Mounting center)
‡310 (recommended
mounting dimension)
Reference
surface
6 (
M
e
cha
nical e
n
d)
6 (Mechani
cal e
nd)
Arm 2
stopper
3-M4, depth 8
Same on
opposite side
(*1)
Arm 1
stopper
Quick joint for
‡6 air tube
Quick joint for
‡4 air tube
User connector (D-
sub connector for
user wiring, 25-pin,
socket, fastener
size M2.6)
ALM (*3)
Spacer
Outer diameter
‡7, height 10,
M4, depth 5
(*2) Detail view of panel (1/2) Detail view of arm tip (1/2)
‡14 hollow
‡
Section A-A
B: Detail view of base mount
4- ‡14, board
‡30 counterbored, depth 5
*1: The prepared holes denoted by “3-M4, depth 8” are through
holes connecting the side faces of the arm.
*2: The external force acting upon the spacer shall be kept to
30 N or less in axial direction or 2 N-m or less in rotating
direction (per spacer).
*3: The LED will actuate when the user wires the applicable
lines in such a way that 24 VDC is applied to the user-wired
LED terminal upon output of a signal from the controller.
Arm 2
stopper
* The inverse specification is installed upside down.
BK switch
(brake release
switch)
‡144
‡188