KB Electronics KBVF-23P - Manual (Page 24)

6.1 AC Line Input Voltage Selection
(Jumper J1 (Models KBVF-21D,
22D, 23D, 24D, 26D Only)) –
Jumper J1 is factory set to the
“230V” position for 208/230 Volt
AC line input. For 115 Volt AC line
input, set Jumper J1 to the
“115V” position. Jumper J1 is
located on the upper PC board.
See Figures 7 and 8.
For 115 Volt AC line input, on
Model KBVF-26D, the jumper
must be removed and
installed onto the
“115VAC” position. Using
pliers, gently rock the
female terminal back and
forth vertically while
pulling it upward. See
Figure 9, on page 25.
24
FIGURE 7 – MODELS KBVF-21D, 22D, 23D, 24D
AC LINE INPUT VOLTAGE SELECTION
230 Volt AC Line Input
(Factory Setting)
(J1 Installed in “230V” Position)
115 Volt AC Line Input
(J1 Installed in “115V” Position)
J1
230V 115V 230V 115V
J1
FIGURE 8 – MODEL KBVF-26D AC LINE INPUT VOLTAGE SELECTION
230 Volt AC Line Input
(Factory Setting)
(J1 Installed in “230VAC” Position)
115 Volt AC Line Input
(J1 Installed in “115VAC” Position)
install it onto the "115VAC" position.
For 115 Volt AC Line Input,
remove this terminal and
this terminal.
Do not remove
115VAC
J1
230VAC
115VAC
230VAC
J1