KB Electronics KBDF-48 - Manual (Page 16)

16
6 DRIVE LAYOUT
See Figure 3 for the Drive Layout. See Table 4, on page 17, for description of the Keypad,
4-Digit Display, LEDs, and Potentiometer.
The drive contains 8 LEDs to provide indication of the drive’s status and operating mode (REM,
LCL, FWD, REV, STOP, OL, PGM, Hz). The Keypad is used for Local Operation of the drive.
For Remote Operation see Function Group 2, on page 57. To operate the drive using the
Potentiometer, set Function 2.00 to "0001".
WARNING! Do not depend on the LEDs or the 4-Digit Display to no longer be
illuminated as a guaranteed power off condition. Be sure that the main power switch or
circuit breaker is in the "OFF" position before servicing the drive.
FIGURE 3
DRIVE LAYOUT
(SHOWN WITH FRONT COVER REMOVED)
(SEE DESCRIPTIONS, ON PAGE 17)
MODULE
MEMORY
REV
FWD
STOP
RUN