KB Electronics KBDF-48 - Manual (Page 68)

68
APPENDIX C
OPTIONAL MEMORY MODULE
(PART NO. 9634)
The optional plug-in memory module can store up to 4 programs for cloning and archiving. This
is in addition to the (4) on-board programs. The drive is factory set to use Program 1 on the
drive or Memory Module (Function 6.12 set to "0001". For Program 2, Set Function 6.12 to
"0002". For Program 3, set Function 6.12 to "0003". For Program 4, set Function 6.12 to "0004".
Remove the cap to install the Memory Module. See Figure 48.
FIGURE 48
MEMORY MODULE
MEMORY
MODULE
To Copy Program 1 from the Memory Module to the Drive's Active Program
Press the PROGRAM/DISPLAY Key for 2 seconds (while the drive is in Stop Mode). The drive
will read Program 1 from the Memory Module and save it to the Active Program in the drive.
"CP-1" will be displayed if the copy was successful.
To Copy the Drive's Active Program to the Memory Module
Press the READ/ENTER Key for 5 seconds (while the drive is in Stop Mode). The drive's Active
Program will be copied to Program 1 of the Memory Module. "CP-2" will be displayed if the copy
was successful.