KB Electronics KBDF-48 - Manual (Page 38)

38
FIGURE 28
UNIDIRECTIONAL PRESET FREQUENCY SELECTION WITH 2-WIRE START/STOP
CONNECTIONS AND DRIVE PROGRAMMING
*Factory setting.
FIGURE 29
UNIDIRECTIONAL PRESET FREQUENCY SELECTION WITH 3-WIRE START/STOP
CONNECTIONS AND DRIVE PROGRAMMING
*Factory setting.
8.4.2.5 MODBUS COMMUNICATION
The optional DIDF RS-232 and RS-485 Modbus RTU Communication Module allows direct
communication between the drive and Modbus RTU protocol. See Appendix B, on page 68.
Program Function Setting
1.00: Run/Stop-Forward/Reverse Control 0001: External contacts
3.00: Stored Set Frequency (Hz) 00.00 Hz
7.00: Multi-Function Input Terminal 1 (TB1 Term. 5) 0000: Preset Frequency Operation*
7.01: Multi-Function Input Terminal 2 (TB1 Term. 6) 0001: Preset Frequency Operation*
7.02: Multi-Function Input Terminal 3 (TB1 Term. 7) 0002: Preset Frequency Operation*
7.03: Multi-Function Input Terminal 4 (TB1 Term. 8) 0009: Reset*
7.04: Multi-Function Input Terminal 5 (TB1 Term. 9) 0010: N.O. Start (2-Wire or 3-Wire Start/Stop)*
Program Function Setting
1.00: Run/Stop-Forward/Reverse Control 0001: External contacts*
3.00: Stored Set Frequency (Hz) 00.00 Hz
7.00: Multi-Function Input Terminal 1 (TB1 Term. 5) 0000: Preset Frequency Operation*
7.01: Multi-Function Input Terminal 2 (TB1 Term. 6) 0001: Preset Frequency Operation*
7.02: Multi-Function Input Terminal 3 (TB1 Term. 7) 0002: Preset Frequency Operation*
7.03: Multi-Function Input Terminal 4 (TB1 Term. 8) 0011: N.C. Stop (3-Wire Start/Stop)
7.04: Multi-Function Input Terminal 5 (TB1 Term. 9) 0010: N.O. Start (2-Wire or 3-Wire Start/Stop)*