KB Electronics KBDF-48 - Manual (Page 17)

17
TABLE 4
DESCRIPTIONS OF 4-DIGIT DISPLAY, LEDs, KEYS, AND POTENTIOMETER
No. Feature Description
1
4-Digit Display: Provides readout of drive status, operating parameters,
and faults.
2 REM LED: Indicates that the drive is set for Remote Operation.
3 LCL LED: Indicates that the drive is set for Local (Keypad) Operation.
4 FWD LED: Indicates that the drive is set for Forward Direction.
5 REV LED: Indicates that the drive is set for Reverse Direction.
6 STOP LED: Indicates that the drive is in Stop Mode.
7 OL LED: Indicates that the drive is in Overload.
8 PGM LED: Indicates that the drive is in Program Mode.
9
Hz LED: Indicates that the display is set to show Drive Output Frequency
(in Hz).
10 RUN
STOP
RUN / STOP Key: Starts and Stops the drive.
11
REV
FWD FWD/REV Key: Changes motor direction.
12
Up Key: Increases Output Frequency, Set Frequency, Function Number
Value, and Code setting.
13
Down Key: Decreases Output Frequency, Set Frequency, Function
Number Value, and Code setting.
14
Left Shift / Reset Key: Moves the changeable digit or Resets the drive
after a fault has cleared.
15
LOCAL / REMOTE Key: Used to toggle between Local (Keypad)
Operation or Remote Operation. When in Local (Keypad) Operation, the
LCL LED will remain illuminated. When in Remote Signal Operation, the
REM LED will flash 1 second on and 1 second off.
16
PROGRAM / DISPLAY Key: Puts the drive into Program Mode or Display
Mode. If pressed while Set Frequency is displayed, the previously entered
Function Number will be shown. If pressed while Function Number is
displayed, the Set Frequency will be shown. When more than one display
function is enabled, the key is used to toggle between displays.
17 READ / ENTER Key: Reads or Enters a Function Value or Code Setting.
18
Potentiometer: Sets the Drive Output Frequency in lieu of the Keypad. To
change the Keypad for Potentiometer Operation, set Function 2.00 to
code "0001".