LEDGlow Advanced 3 Million LED Underbody Kit & Wheel Well Lights - Manual (Page 3)

Wheel Well Installation:
1. Arrange the tubes out on the ground and test the wheel well tubes to ensure proper functionality before installing.
2. Before mounting each tube, please refer to the schematic below to ensure correct placement and tube direction. Note: The tubes can
be installed either behind the strut facing the rim or above the tire to the fender well. The connectors for each tube must be
facing the rear of the vehicle. When running the wires to the USB hub, be sure to keep them away from any moving parts and
at least 6 inches from any direct heat source.
3. Once the kit has been laid out properly and you have determined it is functioning properly, you can proceed with the rest of the
installation.
4. First, mount the driver’s side front tube with the green sticker to your wheel well, either behind the strut or above your tire to the
fender well. Make sure the USB connector is facing the rear of the vehicle using the included self-tapping screws through the end caps
on each tube. Make sure the tube is at least 6 inches away from any direct heat source and away from all moving parts. Use the
included wire ties to secure all excess wire.
5. Second, mount the passenger’s side front tube with the green sticker to your wheel well, either behind the strut or above your tire to
the fender well. Make sure the USB connector is facing the rear of the vehicle using the included self-tapping screws through the end
caps on each tube. Make sure the tube is at least 6 inches away from any direct heat source and away from all moving parts.
Use the included wire ties to secure all excess wire.
6. Next, mount the passenger’s side rear tube with the blue sticker to your wheel well, either behind the strut or above your tire to the
fender well. Make sure the USB connector is facing the rear of the vehicle using the included self-tapping screws through the end caps
on each tube. Make sure the tube is at least 6 inches away from any direct heat source and away from all moving parts. Use the
included wire ties to secure all excess wire.
7. Next, mount the driver’s side rear tube with the blue sticker to your wheel well, either behind the strut or above your tire to the fender
well. Make sure the USB connector is facing the rear of the vehicle using the included self-tapping screws through the end caps on
each tube. Make sure the tube is at least 6 inches away from any direct heat source and away from all moving parts. Use the
included wire ties to secure all excess wire.
8. Now, connect one of the male ends of the USB linking cable to the USB hub with underbody tube connections and the other male end
of the linking cable to the USB hub that came with the wheel well kit. Now that both USB hubs are linked, plug the USB connections
from the wheel well tubes to the USB hub.
9. Mount the wheel well kit’s USB hub in a safe and secure location inside of your vehicle or to your vehicle’s fire wall away from any
direct heat source in a dry location. Run the USB hub’s cable from the firewall through a pre-existing hole with a grommet in your
firewall. If you do not have a pre-existing hole in the firewall, you can drill one, just be sure to use a rubber grommet to ensure the
lead wire is not cut or pinched.
10. It is imperative to make sure that the wires are not mounted to any direct hear source or to any moving parts. Any excess length on the
tube power wire will have to be bound up and secured tightly.
11. DO NOT SHORTEN OR CUT ANY OF THE WHEEL WELL TUBE POWER WIRES. THIS WILL DESTROY THE KIT
AND VOID ALL WARRANTIES.
12. Lower the vehicle, if it was raised, power the kit ON and test the underbody and wheel well kits for full functionality.
13. Once the vehicle is on the ground, turn the steering wheel as far as it can go in both directions to ensure the tube and/or wires are not
coming in contact with your tires or any other moving parts.