LEDGlow Single Color LED Wheel Well Kit User Manual
Page 2
8.
Connect the red power wire to a positive (+) 12 volt source. If
you need to extend the red and black power wires, be sure to use 16 or 18
gauge automotive grade wiring. If you are running the wires to your
vehicle’s battery, it must go through the firewall by an existing grommet
or by drilling a hole and adding a new grommet which is available at any
auto parts store. Be sure to install the fuse within 6 inches of the battery. If
you connect the power wires to a switched source, the control box will not
remember the pattern the kit was last on. If you connect the power wires
to a constant source, the control box will remember the pattern the kit was
last on. Also when connected to a constant source, you will need to
physically turn the kit off as it will not power down with your vehicle. If
you want to tap power from your vehicle’s fuse box, we recommend using
LEDGlow’s Expandable Circuit which is available at
9.
Connect the black wire to a good, unpainted metal surface under
the dash at any main bracket or grounding block. If you are connecting the
wires to your vehicle’s battery, connect the black wire to the negative (-)
terminal of the battery or any engine ground.
10. Next, mount the junction box on the firewall away from heat and in a dry location. The junction box was not designed
to withstand the elements. Corrosion to the junction box will void all warranties and may cause the kit to fail.
11. Starting with the rear wheel well tubes, run the wires to the location on the junction box. Connect the white stripe wire
of the tube to the (+) port on the junction box and the solid black wire to the (-) port on the junction box. Make sure to
secure the wires to any suspension parts by using the included zip ties. Leave at least 10 inches between the exhaust
and the wires.
12. Lower the vehicle if it was raised and test your new kit.
For accessories, replacement parts and/or technical support, please visit
for more information.