LEDGlow Single Color Golf Cart Kit User Manual
Page 2
8.
If you need to extend the power wires, be sure to use a 16 or 18 gauge
automotive grade wire. If you are running the power wire to the battery and must go
through metal, use an existing grommet or drill a hole and add a new grommet, which is
available at any auto parts store. Be sure to install the fuse within 6 inches of the power
source. If you connect the power wire to a switched 12 volt source, then it may not
remember the previous color and pattern it was last on. If you are running the wire to the
fuse block, LEDGlow recommends that you install the wire using our Expandable
Circuit, which is available online a
r at any auto parts store.
9.
Connect the black wire to a good ground source, grounding block, or you can
connect it directly to the negative terminal of the battery.
10. Next, mount the junction box on the golf cart away from heat and in a dry
location. The junction box must be mounted away from moisture and the elements.
CORROSION TO THE JUNCTION BOX WILL VOID ALL WARRANTIES
AND MAY CAUSE CONTROLLER FAILURE.
11. Starting with the rear tubes, run the wires to the dry location of the junction
box. Make sure to secure the wires tightly when going around any suspension parts and
exhaust. Leave at least 10 inches between the exhaust and the wires. Also, be sure to
keep all wires and tubes away from any suspension parts. If a wire is pinched, the kit
may malfunction and could void the warranty. Run the wires along one side of the golf
cart and make sure to tightly secure it. Then, run the front tube wires to the junction box.
12. Once again, make sure the wire is mounted away from heat and moving
parts. Any excess wire will have to be bound and secured tightly with zip ties.
13. Now that the tubes’ wires are connected to the junction box, plug the male
connector of the control box into the female port of the junction box.
14. Lower the golf cart if it was raised, and test your new LEDGlow Single Color Golf Cart Underbody Kit.
15. With the golf cart on the ground, turn the steering wheel as far as it can go in both directions to ensure that there will be no tubes
and/or wires coming in contact with the tire as you’re driving. If a tube or wire is damaged by the tire, the warranty will be voided.
For accessories, replacement parts and/or technical support please visit
or more information.