LEDGlow LiteTrike I & II Advanced Million Color LED Lighting Kits User Manual
Page 3
Wireless Remote Functions:
This kit provides multiple lighting patterns and several brightness levels, which are easily operated by using the
included wireless remote. The wireless remote features four buttons, “A, B, C, D”
Button A: Cycles through 15 solid colors, as well as a color cycle and color fade pattern.
Hold for 5 seconds to select brightness level when on a solid color.
Button B: Activates the strobing pattern when a single color is selected.
Hold to increase pattern speed when on a color cycle/color fade pattern.
Button C: Activates fading pattern when a single color is selected.
Hold to decrease pattern speed when on color cycle/color fade pattern.
Button D: Power On/Off
Reprogramming the Wireless Remote:
Remove the end cap from the control box and slide the circuit board out of the housing. Remove the tape from around
the circuit board. Once the tape is removed, you will see a white box on the circuit board that says “LED”. Using a paper clip,
touch the two silver tabs that are located to the right of the “LED” box called “K1”. Once you touch the two silver tabs, a red
LED will illuminate. While the LED is lit, press any button on the wireless remote and you will see the LED flash and turn off.
Press the “D” button on the remote to power the kit and ensure it is functioning properly. Place the tape back on the circuit board
and slide it back into the housing of the control box.
Troubleshooting:
If the kit or lights do not appear to operate, first check the installed inline mini fuse. If the fuse is blown, check the
wires on the entire kit to ensure they are not cut, pinched or scorched. If there is no damage to any of the wires and no water
damage is visible to the control box, replace the fuse and test the kit again. If the inline fuse is intact, clean both the positive and
negative terminals of the battery. Corrosion to the battery terminals can cause a poor connection or simulate being disconnected.
For accessories, add-on kits, replacement parts and/or Technical Support, please visit
or more information.