LEESON FHP Series NEMA 4x Variable Speed Drive - Manual (Page 15)

6
• It is recommended that the drive be oriented with the
chassis vertical for best heat dissipation. Horizontal
mounting, while acceptable, may require some thermal
derating.
• Four 0.19-inch (5 mm) wide slots accept #8 pan head
screws. Fasten the heatsink chassis to the subplate.
• Drive components are sensitive to electrostatic fields.
Avoid direct contact with the circuit board. Hold the drive
by the chassis only.
Mounting
Warning
DO NOT install, rewire, or remove this control
with input power applied. Doing so may cause
fire or serious injury. Make sure that you read
and understand the Safety Warnings before
attempting installation.
NOTE: Horizontal mounting may require
derating the drive. See your LEESON
representative for more information
ƽ