LEESON FHP Series NEMA 4x Variable Speed Drive - Manual (Page 48)

39
E2 (ENABLE)
E1 (COMMON)
S1
S2
D
S3
JOG
TB501
RUN
NORMALLY OPEN
RUN/JOG
PUSHBUTTON RUN/JOG
SWITCH
(motor coasts to stop)
RUN/JOG switch
Using a RUN/JOG switch is recommended in applications
where quick stopping is not needed and frequent jogging is
required. Use a single-pole, two-position switch for the
RUN/JOG switch, and a single-pole, normally open,
momentary operated pushbutton for the JOG pushbutton.
Connect the RUN/JOG switch and JOG pushbutton to
terminal board TB501 as shown in Figure 18 below. The
motor stops when the RUN/JOG switch is set to JOG.
Press the JOG pushbutton to jog the motor. Return the
RUN/JOG switch to RUN for normal operation.
Figure 18. RUN/JOG Switch