LEESON FHP Series NEMA 4x Variable Speed Drive - Manual (Page 23)

14
Connect AC Power input to L1 and L2 as shown in Figures
5 (page 13), depending on the model of drive being used.
NOTE: The 175326.00 drive is equipped with a voltage-
doubler feature, which converts a 115 VAC input to a 230
VAC output, for use with 230V motors. The drive output
current rating remains the same for either AC input voltage.
Use caution when connecting this output.
If the input voltage is 115 VAC and the desired output
voltage is 230 VAC (voltage doubler mode), set jumpers
as shown in Figure 6 (page 15).
If the input voltage is 230 VAC and the desired output
voltage is 230 VAC (no voltage doubler), set jumpers as
show in Figure 6 (page 15).
Refer to Figure 4 (page 4) for jumper locations.
W a r n i n g
Do not connect 230 VAC line
input when the drive is set for
115 VAC input. This will result in severe damage to
the motor. and can lead to explosion and/or injury.
ƽᏘƸ