LEESON SM Series Sub-Micro Inverters - Manual (Page 6)

1.5 SAFETY INFORMATION
General
All operations concerning installation and commissioning, as well as maintenance, must be carried out
by qualified, skilled personnel (IEC 364 and CENELEC HD 384 or DIN VDE 0100 and IEC report
664 or DIN VDE 0110 and national regulations for the prevention of accidents must be observed).
According to this basic safety information, qualified skilled personnel are persons who are familiar with
the installation, assembly, commissioning, and operation of the product and who have the qualifications
necessary for their occupation.
APPLICATION AS DIRECTED
Drive controllers are components which are designed for installation in electrical systems or machinery.
They are not to be used as appliances. They are intended exclusively for professional and commercial
purposes according to EN 61000-3-2.
When installing the drive controllers in machines, commissioning (i.e. the starting of operation as
directed) is prohibited until it is proven that the machine complies with the regulations of the EC
Directive 98/37/EC (Machinery Directive); EN 60204 must be observed. Commissioning (i.e. starting
of operation as directed) is only allowed when there is compliance with the EMC Directive
(89/336/EEC).
The drive controllers meet the requirements of the Low Voltage Directive 73/23/EEC. The
harmonized standards of the series 61800-5-1 DIN/DIN VDE 0160 apply to the controllers.
NOTE: The availability of controllers is restricted according to EN 61800-3. These products can
cause radio interference in residential areas. In this case, special measures can be necessary.
ELECTRICAL CONNECTION
When working on live drive controllers, applicable national regulations for the prevention of accidents
(e.g. VBG 4) must be observed.
The electrical installation must be carried out according to the appropriate regulations (e.g. cable size,
fuses, PE connection).
This manual contains information about installation in compliance with EMC (shielding, grounding,
filters and cables). These notes must also be observed for CE-marked controllers. The manufacturer of
the system or machine is responsible for compliance with the required limit values demanded by EMC
legislation.
Suitable for use on a circuit capable of delivering not more than 5000 rms
symmetrical amperes, 240 V maximum (249 V devices) or 500 V maximum
(400/500 V devices) respectively.
Use minimum 75°C copper wire only.
Shall be installed in a pollution degree 2 macro-environment.
2
WARNING