ZOLL M Series Defibrillator Rev YC - Manual (Page 18)

M S ERIES C ONFIGURATION G UIDE
14
unit is not configured to Auto Analyze On Power Up, it displays the prompt “PRESS
ANALYZE.” You can start an ECG analysis during the CPR interval by pressing the Analyze
button.
Duration of Extra CPR Interval
This parameter allows you to specify the duration of the extra CPR interval (see previous entry).
It has no effect if “Extra CPR Interval Before 1st Analysis” is set to “No.”
Auto Transmit After 12 Lead
When enabled, the unit will automatically enter the transmission setup screen following
completion of a 12-lead analysis.
To fax using 2x6 format, this must be set to “Yes.”
Fax/Communication Phone Numbers
Allows the user to pre-configure up to 24 locations and phone numbers and delete obsolete
phone numbers. The M Series uses the phone numbers to transmit data to a fax machine or
Catalyst MUSE system following 12-lead analysis.
If you are transmitting to a Catalyst MUSE system, you can configure multiple phone numbers
to access the same system. This will enable you to quickly try alternate numbers if you
encounter difficulty transmitting to the Catalyst MUSE system. The system administrator
provides these numbers when you initially set up access to the system. See Appendix B of the
12-Lead ECG Monitoring insert (part number 9650-0215-01) for more information.
You must also configure the Catalyst MUSE site and location identifiers before you can
transmit to a Catalyst MUSE system. See the “MUSE Site and Location” section of this guide.
It is also recommended that you set up the M Series device identifier. See “Device Identifier”
on page 8 for more information.
Updating Fax/Communication Information
To transmit data to a fax machine or a Catalyst MUSE system, you must configure the
following:
• location of the medical facility to which data will be transmitted
• phone number to which data will be transmitted
• type of data to be transmitted (“Fax” if transmitting to a fax machine; “Data” if transmitting
to Catalyst MUSE)
To update fax/MUSE communications phone numbers:
1. From the main System Configuration menu, press the Next Item softkey until “FAX/
COMMUNICATION PHONE NUMBERS” highlights.
2. Press Change Value softkey. The Phone Numbers menu displays:
6\VWHP&RQILJXUDWLRQ
1H[W

'HOHWH 3UHY

'HWDLOV


5HWXUQ
0HWUR+RVSLWDO 
BBBBBBBBBBBBBBBBB
BBBBBBBBBBBBBBBBB
BBBBBBBBBBBBBBBBB
BBBBBBBBBBBBBBBBB
BBBBBBBBBBBBBBBBB
BBBBBBBBBBBBBBBBB
BBBBBBBBBBBBBBBBB
3+21(180%(56