5 installing components into the ec-1040gb, 1 remove the top cover, Nstalling – IEI Integration EC-1040G User Manual
Page 35: Omponents into the, Ec-1040gb
EC-1040GB Workstation
Page 25
Step 8:
Install the PCI or ISA expansion cards (optional).
Step 9:
Connect all required cables.
Step 10:
Reinstall the CPU card clamp.
Step 11:
Close the top cover.
Step 12:
Install the keyboard (optional).
Step 13:
Mount the workstation.
Step 0:
4.5 Installing Components into the EC-1040GB
NOTE:
This section gives a generic description of the component installation process
for the EC-1040GB rackmount workstation.
WARNING:
Failure to follow the installation procedures outlined in this section may cause
severe damage to the EC-1040GB rackmount workstation. Please follow the
installation instructions carefully.
4.5.1 Remove the Top Cover
The top cover is secured to the EC-1040GB rackmount workstation with six screws (three
each on the left and right panels). To remove the top cover, please follow the steps below.
Step 1:
Remove the six top cover retention screws (three each on the left and right
panels). (See Figure 4-1)