3 3.5” disk drive – IEI Integration EC-1040G User Manual
Page 42
EC-1040GB Workstation
Page 32
Figure 4-8: 3.5” to 5.25” Drive Bay Rack Retention Screws
Step 3:
Remove the drive bracket from the EC-1040GB rackmount workstation (see
Section 4.5.3).
Step 4:
Remove the 3.5” drive bracket from the 5.25” drive bracket (see Section 4.5.5).
Step 5:
Install the 3.5” to 5.25” drive bay rack into the drive bracket (see Section 4.5.6)
Step 0:
4.5.6.3 3.5” Disk Drive
To install a 3.5” disk drive, follow the instructions below.
Step 1:
Remove the drive bracket from the EC-1040GB rackmount workstation
(see Section 4.5.3).
Step 2:
Remove the 3.5” drive slot blank plate (see Section 4.5.4).
Step 3:
Slide a 3.5” disk drive into the 3.5” drive bracket. Make sure the IDE/SATA
connector and the power connectors of the drive are facing the rear of the drive
bracket.
Step 4:
Insert the appropriate number of retention screws into each side of the 3.5” disk
drive through the 3.5” drive bracket (Figure 4-9).
Step 0: