7 reinstall the drive brackets, 8 install the backplane, Figure 4-9: 3.5” disk drive retention screws – IEI Integration EC-1040G User Manual
Page 43
EC-1040GB Workstation
Page 33
Figure 4-9: 3.5” Disk Drive Retention Screws
4.5.7 Reinstall the Drive Brackets
After the drives have been installed, reinstall the drive brackets into the chassis.
NOTE:
It might be easier to connect the disk drive IDE/SATA connectors to the ribbon
cables and the disk drive power connectors to the PSU before the drive
brackets are reinstalled into the chassis.
Step 1:
Remount the drive brackets in the original position they were removed from.
Step 2:
Make sure all drive bracket retention screw holes are properly aligned with the
corresponding retention screw holes in the workstation.
Step 3:
Reinsert all drive bracket retentions screws.
Step 0:
4.5.8 Install the Backplane
To install a backplane, follow the instructions below.
Step 1:
Install the correct amount of copper pillars into the base of the chassis