IEI Integration EC-1040G - Manual (Page 46)

EC-1040GB Workstation
Page 36
4.5.9 Install the CPU Card
CAUTION
Before a CPU card is inserted into the backplane, make sure the CPU card has
been correctly prepared and that all the CPU card jumper settings are
configured correctly. For CPU card component installation procedures, please
refer to the user manual that came with the CPU card.
CAUTION
Depending on the location of the CPU card, the disk drive ribbon cable
connectors and other peripheral device cable connectors may have to be
connected to the CPU card before it can be installed.
To install a CPU card onto the backplane, follow the instructions below:
Step 1: Remove the slot bracket from the chassis rear panel by removing the slot cover
retention screw (Figure 4-12).