IEI Integration EC-1040G - Manual (Page 40)

EC-1040GB Workstation
Page 30
Figure 4-6: 3.5” Drive Bracket Retention Screws
Step 3: Remove the 3.5” drive bracket from the 5.25” drive bracket. Step 0:
4.5.6 Install Drives
4.5.6.1 5.25” Disk Drive
The drive bracket supports three 5.25” disk drives. To install a 5.25” disk drive, follow the
instructions below.
Step 1: Remove the drive bracket from the EC-1040GB rackmount workstation (see
Section 4.5.3).
Step 2: Remove the 3.5” drive bracket from the 5.25” drive bracket (see Section 4.5.5).
Step 3: Remove the appropriate drive slot blank plate (see Section 4.5.4).
Step 4: Slide the 5.25” disk drive into the drive bracket. Make sure the IDE/SATA
connector and the power connector of the drive are facing the rear of the
bracket.