Watlow LogicPro - Manual (Page 187)

LogicPro User’s Guide Chapter 11: User Defined Function Blocks
Doc.# 28002-00 Rev 3.00 Watlow Anafaze 171
Figure 11.2 Add Symbol Definition Dialog Box
To edit an Input, Output, or Internal:
1. Select a symbol by clicking on it.
2. Click [Edit] . The Edit Symbol Definition dialog box,
shown in Figure 11.3, appears.
3. Edit the name of the symbol in the Name field, if
necessary.
4. Edit the type of symbol from the Type field, if
necessary.
5. Click [OK] to replace the old symbol with the new
symbol in the group.
NOTE! When type is “Real” the name MUST start with the
letter ‘R.’
Figure 11.3 Edit Symbol Definition Dialog Box