Closing the simulation – Watlow LogicPro User Manual
Page 249
LogicPro User’s Guide
Chapter 14: Simulation
Doc.# 28002-00 Rev 3.00
Watlow Anafaze
233
Viewing Individual Steps and Actions within a
Simulation
In an SFC diagram, double-clicking on the Action to the right
of the step opens a window displaying this Action in
simulation mode.
This works regardless of the programming language used in
the Action. If the Action is another SFC, you can continue to
drill down and see more detail. Each time you double-click on
the Action another window opens.
If the Action is a Ladder Diagram or a Function Block
Diagram you can not go any deeper. However, you can
change constants by double clicking on the Function Block.
See the section entitled Change Simulation Constants on page
232 for more information.
Closing the Simulation
1.
Select the
File
menu.
2.
Select
Close
.
3.
Select
Simulation.