Watlow LogicPro - Manual (Page 248)

Chapter 14: Simulation LogicPro User’s Guide
232 Watlow Anafaze Doc.# 28002-00 Rev 3.00
Variables whose values are determined by the program will
not retain values set in the
Change Variables dialog box.
Logic scans will overwrite these variables’ values.
NOTE! If you are not in the continuous scan mode, the
logic will not reflect the changes to a variable until
a scan takes place. Therefore, to see the effects
you must trigger at least one scan cycle.
Change Simulation Constants
In a Ladder diagram, double click on a function block to view
and change a constant, see Figure 14.5.
Figure 14.5 On-Line Function Block Constant
Change
NOTE! Constants can only be changed in Ladder dia-
grams. You cannot change constants in a Func-
tion Block diagram.