Watlow LogicPro - Manual (Page 237)

Doc.# 28002-00 Rev 3.00 Watlow Anafaze 221
13
Compiler Setup
LogicPro uses the Borland C++ 4.0 compiler, both for
simulation and for logic programs down loaded to a
controller.
Setting up the Compiler
The compiler configuration tells LogicPro the location (path)
of the compiler, linker and library executables along with the
Include and Library paths.
Installation sets up the compiler paths. Under most
circumstances, the default settings are adequate. If the paths
need to be modified, use the following procedure to define the
compiler paths:
1. Select the Options menu.
2. Select Resource Compiler Selection . This will
cause the Resource Compiler Selection dialog box
to open, as shown in Figure 13.1.
Figure 13.1 Simulation Compiler