Watlow Series 96 - Manual (Page 32)

6 . 2 ■ P a r a m e t e r s Wa t l o w S e r i e s 9 6
Operations Page / Monitor Menu
Operations Page
The Operations Page contains five menus:
Active if Auto-Manual Operation
Mode (User Menu) is set to
[auto] (automatic) and Opera-
tions Page Lock (Lockout
Menu) is not set to
[hide].
305 r/w [`OFF] (0) [`OFF] off or cancel an
auto-tune in progress
(0)
[tune] initiate an
auto-tune (1)
[Pid1] Set 1 only (2)
[Pid2] Set 2 only (3)
[`Aut] Auto-tune
Initiate or cancel an
auto-tune.
Active if Operations Page Lock
(Lockout Menu) is not set to
[hide].
301 r/w [Auto] (0) [Auto] Auto mode (0)
[Man] Manual mode
(1)
[A-M] Auto-Manual**
Operation Mode
Select whether the
controller is under
auto or manual con-
trol.
[User] User Menu
[Oper] Operations Page
Active if [E`fn] (Input 2 Menu)
is not set to [none] and Opera-
tions Page Lock (Lockout
Menu) is not set to
[hide].
201 r [true] true (1)***
[FALS] false (0)*** [E`St] Event Input Status
Monitor the event
input status.
Active if Ramping Mode (Global
Menu) is not set to [`Off] and
Operations Page Lock (Lockout
Menu) is not set to
[hide].
203 r [rpSP] Ramping Set
Point**
Monitor the ramping
set point.
Active if Operations Page Lock
(Lockout Menu) is not set to
[hide].
103 r [Pcnt] Percent Output
Monitor the control
output power level.
Active if Input 2 (Input 2 Menu)
is not set to [`Off] or [E`In]
and Operations Page Lock
(Lockout Menu) is not set to
[hide]
.
105 r [Pr2`] Process 2**
Monitor the process
2 value.
[mon] Monitor:
comms value (0)
[mon] Monitor Menu
[Oper] Operations Page
Active if Operations Page Mode
Lock (Lockout Menu/Factory
Page) is not set to
[hide] .
[Mon] Monitor
[User] User
[pid1] PID 1
[Pid2] PID 2 (if output
2 is Active)
[Alm] Alarm (if any
alarms are active)
[Oper] Operations Page
Select
Go to an operations
menu.
Display Parameter Range Default Modbus Conditions for
(Modbus Value) Register Parameters to Appear
read/write
*These parameters are added if the ramping software option has been ordered (96 _ _ - _ _ _ _ - AA _ _ ) .
**These parameters are removed if the ramping software option has been ordered (96 _ _ - _ _ _ _ - AA _ _ ) .
***Numbers in parentheses are the ordinals/enumerators for use in Modbus communications.