Watlow Series 96 - Manual (Page 48)

Active: Always 1400-1415
r/w [``p1]:[A-m]
(Operation
Mode)
[``p2]:[`Aut]
(Auto-tune)
[``p3]:[Pcnt]
(Percent
Power)
[``p4]:[CAL1]
(Calibration
Offset)
[``p5] to
[`p16]:
[none]
[none] none (0)
[`Pr2] Process 2 (1)
[Pcnt] Percent Output
(2)
[rPSP] Ramping Set
Point (3)
[E`St] Event Input
Status (4)
[a-m] Operation
Mode (5)
[`aut] Auto-tune (6)
[atSP] Auto-tune Set
Point (7)
[`SP2] Set Point 2 (8)
[E`SP] Event Set Point
(9)
[`L-r] Local or Re-
mote Mode (10)
[Cal1] Calibration Off-
set (11)
[Pb`1] Propband 1
(12)
[It`1] Integral 1 (13)
[de`1] Derivative 1
(14)
[re`1] Reset 1 (15)
[rA`1] Rate 1 (16)
[Ct`1] Cycle Time 1
(17)
[db`1] Dead Band 1
(18)
[pb`2] Propband 2
(19)
[IT`2] Integral 2 (20)
[de`2] Derivative 2 (21)
(Continued Next Page)
[``P1] to [`P16] Custom
Prompt number**
(1 to 16)
Choose an opera-
tions prompt to be
in custom prompt
slot.
[CUST] Custom Menu**
[Fcty] Factory Page
Active: Always [CUst] Custom Menu**
[`LOC] Lockout Menu
[dIag] Diagnostics
Menu
[cin1] Calibration 1
Menu
[cin2] Calibration 2
Menu**
[cout] Calibration
Menu
[fcty] Factory Page Se-
lection
Choose factory menu
to enter.
Factory Page
The factory page contains six menus:
Display Parameter Range Default Modbus Conditions for
(Modbus Value) Register Parameters to Appear
read/write
*These parameters are added if the ramping software option has been ordered (96 _ _ - _ _ _ _ - AA _ _ ) .
**These parameters are removed if the ramping software option has been ordered (96 _ _ - _ _ _ _ - AA _ _ ) .
NOTE: For more information about how parameter settings affect the controller’s operation, see Chapter Five, Features.
6 . 1 8 ■ P a r a m e t e r s Wa t l o w S e r i e s 9 6
Factor
y Page / Custom Menu