Yokogawa µR20000 - Manual (Page 259)

App-7
IM 04P02B01-01E
Append
x
1
2
3
4
5
6
7
8
9
10
11
12
App
Index
When the Interval Is Set to Manual
If you select Manual, you can set the interval.
• Chart Speeds That Allows Perodc Prntout
Pen Model Dot Model
Chart Speed Prntout Avalablty Chart Speed Prntout Avalablty
6/12-dot 18/24-dot
Up to 9 mm/h No Up to 9 mm/h No No
10 to 1500 mm/h Yes 10 to 50 mm/h Yes Yes
1600 mm/h or higher No 51 to 100 mm/h Yes No
101 mm/h or higher No No
• Interval Settngs
Select from 10, 12, 15, 20, 30 minutes, 1, 2, 3, 4, 6, 8, 12, and 24 hours.
• Prntout Items
Item Number of Lnes Intal Settng Notes (Ref. Secton)
Date/Time 2 - Always printed.
Measured value
and alarm status
1 line/channel Printed Print or not print selectable for each
channel (section 6.6).
Scale 2 Printed Print or not print selectable (section 7.7).
Pen color
(Pen model only)
1 Printed Print or not print selectable (section 7.7).
Chart speed 1 - Always printed.
• Relatonshp between the Prntout Items and Interval
The next periodic printout does not start until all items of the previous periodic printout
are printed.
If all items cannot be printed in the specified interval, the printout interval increases by
an integer multiple of the specified interval.
Actual
interval
Periodic printout
Periodic printout
Specified interval
Example: 12 dot model, chart speed: 20 mm/h, interval: 1 hour, all other settings at
default.
• This setting requires 17 lines to be printed which is equivalent to approximately
43 mm* of chart paper.
• The length of chart paper that is fed within the interval is 20 mm.
* The length of chart paper needed in the printout varies depending on the chart speed
and trend recording interval.
Not all items can be printed in the specified interval of 1 hour.
The actual interval is 3 hours.
If you want to print at a shorter interval, change the settings as follows:
• Reduce the number of printed items.
• Increase the chart speed within the printable range.
Note
Measurement, display, periodic printout, and trend recording (dot model) are not performed by
setting unused channels to “Skip” (see section 5.1).
Appendx 2 Perodc Prntout Interval