Yokogawa µR20000 - Manual (Page 58)

2-3
IM 04P02B01-01E
Before
Us
ng
the
Recorder
1
2
3
4
5
6
7
8
9
10
11
12
App
Index
Installaton Procedure
The recorder should be mounted on a steel panel of thickness 2 mm to 26 mm.
1. Insert the recorder from the front side of the panel.
2. As shown in the figure below, mount the recorder to the panel using the mounting
brackets that come with the package.
• Use two brackets to support the top and bottom or the left and right sides of the
case. (Remove the seal that is covering the holes for the mounting brackets
beforehand.)
• The proper torque for tightening the mounting screws is 0.7 to 0.9 N•m.
• Mount the recorder to the panel according to the procedure below.
• First, attach the two mounting brackets and temporarily fasten the attachment
screws.
• Next, fix the recorder in place by tightening the attachment screws with the
appropriate torque. When the recorder is approximately perpendicular to the
panel as you fasten the screws, press the mounting bracket against the case
so that they are in contact with each other.
(The figure shows the case when the mounting brackets are used on the top and bottom of the case.)
Screw temporarily Fix in place
Front
Panel
Panel
Mounting bracket
Mounting bracket
Torque driver
(flat blade)
Attachment screw
Case
In contact
with each other
Attachment screw
CAUTION
Tightening the screws too much can deform the case or damage the bracket.
For the dimensional drawings and panel cut dimensions, see section 12.7.
2.2 Installaton