Brocade Virtual ADX MIB Reference (Supporting ADX v03.1.00) - Manual (Page 154)

142 Brocade Virtual ADX MIB Reference
53-1003312-01
OSPF interface configuration tables
OSPF interface 2 configuration table
snOspfIfMd5AuthKey
brcdIp.1.2.4.4.1.1.14
Syntax: OctetString Read-write Specifies the MD5 authentication key. If the object
“snOspfVirtIfAuthType” is set to MD5, the value of this object is
encrypted and included in each OSPF packet transmitted.
The agent will left-adjust and zero-fill the key to equal 16
octets.
When read, snOspfIfMd5AuthKey always returns a blank.
snOspfIfMd5ActivationWaitTime
brcdIp.1.2.4.4.1.1.15
Syntax: Integer Read-write Determines when a newly configured MD5 authentication key
is valid. This parameter provides a graceful transition from one
MD5 key to another without disturbing the network. All new
packets transmitted after the key activation wait time interval
use the newly configured MD5 key. OSPF packets that contain
the old MD5 key are accepted for up to five minutes after the
new MD5 key is in operation. The range for the key activation
wait time is from 0 – 14400 seconds.
Default: 300 seconds
snOspfIfAreaIdFormat
brcdIp.1.2.4.4.1.1.16
Syntax: Integer Read only Specifies the format of how Area ID will be entered in the
“snOspfIfAreaId” object
•
integer(0) – Integer
•
ipAddress(1) – IP Address
snOspfIfPassiveMode
brcdIp.1.2.4.4.1.1.17
Syntax: Integer Read-write Indicates if passive mode is enabled on this interface:
•
disabled(0)
•
enabled(1)
snOspfIfDatabaseFilterAllOut
brcdIp.1.2.4.4.1.1.18
Syntax: Integer Read-write Determines if the filtering of outgoing OSPF LSA on this
interface is enabled:
•
disabled(0) – Filtering is disabled
•
enabled(1) – Filtering is enabled
snOspfIfMtuIgnore
brcdIp.1.2.4.4.1.1.19
Syntax: Integer Read-write Determines if the MTU detection mode of this interface is
enabled:
•
disabled(0) – MTU detection mode is disabled
•
enabled(1) – MTU detection mode is enabled
snOspfIfNetworkP2mp
brcdIp.1.2.4.4.1.1.20
Syntax: Integer Read-write This object is not supported. Determines if the P2MP mode of
this interface is enabled:
•
disabled(0) – P2MP mode is disabled
•
enabled(1) – P2MP mode is enabled
Name, OID, and Syntax Access Description
snOspfIf2Table
brcdIp.1.2.4.4.2 None Determines if the P2MP mode of this interface is enabled:
•
disabled(0) – P2MP mode is disabled
•
enabled(1) – P2MP mode is enabled
snOspfIf2Entry
brcdIp.1.2.4.4.2.1 None An entry in the OSPF Interface 2 Configuration Table.
snOspfIf2Port
brcdIp.1.2.4.4.2.1.1
Syntax: Integer32 Read only The physical router port of this OSPF interface.
Name, OID, and Syntax Access Description