Brocade Virtual ADX MIB Reference (Supporting ADX v03.1.00) - Manual (Page 273)

Brocade Virtual ADX MIB Reference 261
53-1003312-01
Virtual ADX traps
VRRP trap
Only devices that support VRRP can use the following trap:
snTrapIfIndexAssignmentC
hanged
brcdIp.0.172 snAgGblTrapMessa
ge Informational Generated when the Interface Index (ifIndex)
assignment for a physical interface is
changed.
Sample Trap Message:
System: IfIndex assignment was
changed
snTrapModuleStatusChang
e
brcdIp.0.176 snChasUnitIndex,
snAgentBrdIndex,
snAgentBrdModule
Status, and
snAgGblTrapMessa
ge Notification The operational state of a module changed.
The management entity receiving the
notification can identify the module and the
event by referencing snChasUnitIndex,
snAgentBrdIndex, snAgentBrdModuleStatus.
If the module is down, the varbind
snAgGblTrapMessage contains a text string
that describes the cause.
If the module is up, nothing is displayed for
snAgGblTrapMessage.
Sample Trap Message:
For module UP: System: Module up in
slot <slot-number>
For module DOWN: System: Module down
in slot <slot-number>, reason
<reason. Error Code <error-code>
For standby MP up: System: Standby
Management Module was ready
For standby MP down: System: Standby
Management Module was down,
reason <reason>. Error Code
<error-code>
snTrapl2CAccessLog
brcdIp.0.184 snAgGblTrapMessa
ge Notification This trap is generated to provide information
about state of the I2C access of the
management module.
Sample Trap Message:
last good i2c access, Mux index
0, Mux tap 0, ID 0x9, Addr 0x1,
(SNM2TEMP)
bad i2c access (GIEI = set),
Severity Minor, Mux index 0, Mux
tap2, ID 0x9, Addr 0x1,
(SNM3TEMP)
Trap Name and Number Varbinds Severity Description and Trap Message
snTrapVrrpIfStateChange
brcdIp.0.34 snAgGblTrapMessage Warning A VRRP routing device changed state from
master to backup or vice-versa.
Sample Trap Message:
VRRP intf state changed, intf
<port>, vrid <id>, state
<new-state>.
Trap Name and Number Varbinds Severity Description and Trap Message