Brocade Virtual ADX MIB Reference (Supporting ADX v03.1.00) - Manual (Page 274)

262 Brocade Virtual ADX MIB Reference
53-1003312-01
Virtual ADX traps
OSPF traps
NOTE
You must configure the log adjacency command under the "router ospf" mode to see traps for the
following objects:
ospfIfStateChange trap
ospfNbrStateChange trap
ospfVirtIfStateChange trap
ospfVirtNbrStateChange trap
Trap Name and Number Varbinds Severity Description and Trap Message
snTrapOspfIfStateChange
1.3.6.1.2.1.14.16.2.3 snOspfRouterId (The
originator of the trap)
snOspfIfStatusIpAddres
s
snOspfIfStatusState
(The new state) Informational There has been a change in the state of a
non-virtual OSPF interface. This trap
should be generated when the interface
state regresses (e.g., goes from Dr to
Down) or progresses to a terminal state
(i.e., Point-to-Point, DR Other, Dr, or
Backup).
NOTE: You must configure the log
adjacency command under the
"router ospf" mode to see traps.
Sample Trap Message:
OSPF router id
<snOspfRouterId>, interface
<snOspfIfStatusIpAddress>
state changed to
<snOspfIfStatusState>.
snTrapOspfVirtIfStateChan
ge
1.3.6.1.2.1.14.16.2.4 snOspfRouterId (The
originator of the trap)
snOspfVirtIfStatusAreaI
D
snOspfVirtIfStatusNeig
hbor
snOspfVirtIfStatusState
(The new state) Informational There has been a change in the state of an
OSPF virtual interface. This trap should be
generated when the interface state
regresses (e.g., goes from Point-to-Point to
Down) or progresses to a terminal state
(i.e., Point-to-Point).
NOTE: You must configure the log
adjacency command under the
"router ospf" mode to see traps.
Sample Trap Message:
OSPF router id
<snOspfRouterId>, virtual
interface area id
<snOspfVirtIfStatusAreaID>
neighbor
<snOspfVirtIfStatusNeighbor>
state changed to
<snOspfVirtIfStatusState>.