Brocade Virtual ADX MIB Reference (Supporting ADX v03.1.00) - Manual (Page 76)

64 Brocade Virtual ADX MIB Reference
53-1003312-01
Link Aggregation Group (LAG) table
snLinkAggregationGroupType
brcdIp.1.1.3.30.1.1.1.2
Syntax: Integer Read-create Displays the LinkAggregationGroup type.
snLinkAggregationGroupAdminSt
atus
brcdIp.1.1.3.30.1.1.1.3
Syntax: Integer Read-create Displays the desired deployed state of this
LinkAggregationGroup entry.
NOTE: This is not the operational status. Refer to ifTable for
the operational status.
•
deploy(1)- deploy the LAG and set to LACP active if
dynamic LAG.
•
deployPassive(2)-deploy the LAG and set to LACP
passive if dynamic LAG.
•
undeploy(3)-undeploy the LAG if no more than 2 ports
are enabled.
•
undeployForced(4)-undeploy the LAG regardless
number of ports enabled.
NOTE: undeployForced(4)is a write-only value. In particular,
a row cannot be deployed until the corresponding
instances of snLinkAggregationGroupIfList has been
set.
snLinkAggregationGroupIfList
brcdIp.1.1.3.30.1.1.1.4
Syntax: OctetString Read-create Displays a list of interface indices which are the port
membership of a trunk group. Each interface index is a 16-bit
integer in big endian order.
snLinkAggregationGroupPrimaryP
ort
brcdIp.1.1.3.30.1.1.1.5
Syntax: InterfaceIndex Read-create DIsplays the primary port for the Link Aggregation Group.
This must be set before deploying the LinkAggregateGroup
unless this is a keepalive LinkAggregateGroup.
snLinkAggregationGroupTrunkTyp
e
brcdIp.1.1.3.30.1.1.1.6
Syntax: Integer Read-create Displays the trunk connection type which specifies what the
scheme of load-sharing among the trunk ports is.
snLinkAggregationGroupTrunkThr
eshold
brcdIp.1.1.3.30.1.1.1.7
Syntax: Unsigned32 Read-create DIsplays the number of UP ports needed to keep the trunk
up.
NOTE: This object is not applicable to Keepalive LAGs.
snLinkAggregationGroupLacpTim
eout
brcdIp.1.1.3.30.1.1.1.8
Syntax: Integer Read-create Displays the LACP timeout value this LACP LAG will use.
Applicable for dynamic and keepalive LAG only.
snLinkAggregationGroupIfIndex
brcdIp.1.1.3.29.2.1.1.9
Syntax: InterfaceIndex Read only DIsplays the InterfaceIndex which represents the
LinkAggregateGroup entry in the ifTable and ifXTable.
snLinkAggregationGroupPortCoun
t
brcdIp.1.1.3.30.1.1.1.10
Syntax: Unsigned32 Read only Displays the number of member ports belong to this LAG.
Name, OID, and Syntax Access Description