Measure:lrrdelay, Measure:nwidth – GW Instek GBS-1000 Series Programming Manual User Manual
Page 61

COMMAND SET
61
:MEASure:LRRDelay
Query
Description
Returns the delay between the first rising edge of
source1 and the last rising edge of source2.
Same as: Measure key → F1~F5 → F3 (DelayLRR)
Syntax
< Long >
< Short >
:measure:lrrdelay?
:meas:lrrd?
Returns
<NR3>
Before this
command
Select the two delay channels before entering this
command: :measure:delay1 <NR1>
and :measure:delay2 <NR1>. See pagexx.
Example
:measure:delay1 1
:measure:delay2 2
:measure:lrrdelay?
Select channel 1 and 2
as delay source1/2, and
then measure LRR.
:MEASure:NWIDth
Query
Description
Returns the first negative pulse width timing.
Same as: Measure key → F1~F5 → F3 (–Width)
Syntax
< Long >
< Short >
:measure:nwidth?
:meas:nwid?
Returns
<NR3>
Before this
command
Select the measurement channel before this
command: :measure:source <NR1>. See pagexx.
Example
:measure:source 1
:measure:nwidth?
Select channel 1, then
measure negative pulse
width.