GW Instek GSP-930 User Manual - Manual (Page 171)

ADVANCED OPERATION
169
Save Current
Sequence After a sequence has been edited (and stopped)
it can be saved.
1. Press
Sequence
>Save Sequence[F4] > to save the
sequence.
2. The selected sequence will be saved.
Delete Current
Sequence 1. Press
Sequence
>Delete Sequence [F5] > to delete
the current sequence.
Running a Sequence
Run Mode 1. Press
Sequence
> Sequence[F1] and choose a
sequence.
2. Press Run Mode[F6] and toggle the run mode:
Single Runs the sequence once
only.
Cont. Runs the sequence
continually until Stop
Running Sequence[F7] is
pressed (Note: the Stop
Running Sequence[F7]
option only appears
when the sequence is
running)
Run Sequence 3. Press Run Now[F7] to start running the selected
sequence.
4. Press Stop Running Sequence[F7] to stop the
sequence.
 In single mode the sequence will stop running when
all steps have finished.