GW Instek GSP-930 User Manual - Manual (Page 23)

GETTING STARTED
21
Sweep settings Sweep icon that shows the sweep
status. See page 66 for details.
Trigger settings Trigger icon that shows the trigger
status. See page 79 details.
Pre-amp settings Pre-amplifier icon that shows the
Pre-amplifier status. See from page
48 for details.
Trace and
detection settings Trace icon that shows the trace type
and the detection mode used for
each trace. See from page 72 for
details.
Status Icons Displays the interface status, power source status,
and alarm status, etc. See the Status Icon Overview
on page 22 for a list of the status icons.
Frequency/
Bandwidth
settings Displays the Start, Center and Stop frequencies,
RBW, VBW, Span and Sweep settings.
Entry/Message
area This area is used to show system messages, errors
and input values/parameters.
Trace and
waveforms Main display showing the input signals, traces
(page 72), limit lines (159) and marker positions
(83).