GW Instek GSP-930 User Manual - Manual (Page 176)

GSP-930 User Manual
174
Unit dBm, W
4. Press Frequency[F2] choose measurement
frequency:
Frequency 1MHz~6200MHz
Resolution: 1MHz
5. Press Sensor Mode[F3] to choose measurement
speed (and thus accuracy) of the power meter:
Low Noise: 100ms/sample, typical
Fast: 30ms/sample, typical
6. To create pass fail tests, press Pass/Fail Test[F4]
and set the following parameters:
High Limit[F1] : -100dBm~20dBm
Low Limit[F2] : -100dBm~20dBm
Pass/Fail Test[F3]: On, Off
Pass Icon:
Fail Icon:
7. Press Trigger[F5] to toggle between a free run
(internal) trigger and an external trigger.
Trigger: Free, Ext
Ext trigger input: 3.3V CMOS
8. Press MAX/MIN HOLD[F6] to toggle the
MAX/MIN hold measurements on/off in the
power meter bar.
 The MIN/MAX measurements will be displayed in
the power bar meter in the center of the screen.