GW Instek AFG-2225 User Manual - Manual (Page 233)

REMOTE INTERFACE
233
SOURce[1|2]:PM:STATe
Source Specific
Command
Description Turns PM Modulation on or off. By default PM
modulation is off.
Note Burst or sweep mode will be disabled if PM
modulation is enabled. As only one modulation is
allowed at any one time, other modulation modes
will be disabled when PM modulation is enabled.
Syntax SOURce[1|2]:PM:STATe {OFF|ON}
Example SOUR1:PM:STAT ON
Enables PM modulation
Query Syntax SOURce[1|2]:PM:STATe?
Return Parameter 0 Disabled (OFF)
1 Enabled (ON)
Example SOUR1:PM:STAT?
1
PM modulation is currently enabled.
SOURce[1|2]:PM:SOURce
Source Specific
Command
Description Sets or queries the PM source as internal or
external. Internal is the default source.
Note If an external PM source is selected, the phase
modulation is controlled by the MOD INPUT
terminal on the rear panel.
Syntax SOURce[1|2]:PM:SOURce {INTernal|EXTernal}
Example SOUR1:PM:SOUR EXT
Sets the PM source to external.
Query Syntax SOURce[1|2]:PM:SOURce?
Return Parameter INT Internal
EXT External