GW Instek AFG-2225 User Manual - Manual (Page 237)

REMOTE INTERFACE
237
SOURce[1|2]:SUM:STATe
Source Specific
Command
Description Turns SUM Modulation on or off. By default SUM
modulation is off.
Note Burst or sweep mode will be disabled if SUM
modulation is enabled. As only one modulation is
allowed at any one time, other modulation modes
will be disabled when SUM modulation is
enabled.
Syntax SOURce[1|2]:SUM:STATe {OFF|ON}
Example SOUR1:SUM:STAT ON
Enables SUM modulation
Query Syntax SOURce[1|2]:SUM:STATe?
Return Parameter 0 Disabled (OFF)
1 Enabled (ON)
Example SOUR1:SUM:STAT?
ON
SUM modulation is currently enabled.
SOURce[1|2]:SUM:SOURce
Source Specific
Command
Description Sets or queries the SUM source as internal or
external. Internal is the default source.
Note If an external SUM source is selected, the
amplitude is controlled by the MOD INPUT
terminal on the rear panel.
Syntax SOURce[1|2]:SUM:SOURce {INTernal|EXTernal}
Example SOUR1:SUM:SOUR EXT
Sets the SUM source to external.
Query Syntax SOURce[1|2]:SUM:SOURce?
Return Parameter INT Internal