GW Instek AFG-2225 User Manual - Manual (Page 258)

AFG-2225 Series User Manual
258
Manual A >1 ms pulse is output at the
start of each burst.
Syntax SOURce[1|2]:BURSt:OUTPut:TRIGger:SLOPe
{POSitive|NEGative}
Parameter POSitive Rising edge.
NEGative Falling edge.
Example SOUR1:BURS:OUTP:TRIG:SLOP POS
Sets the trigger output signal slope to positive
(rising edge).
Query Syntax SOURce[1|2]:BURSt:OUTPut:TRIGger:SLOPe?
Return Parameter POS Rising edge.
NEG Falling edge.
Example SOUR1:BURS:OUTP:TRIG:SLOP?
POS
The trigger output signal slope to positive.
OUTPut[1|2]:TRIGger
Source Specific
Command
Description Sets or queries the trigger output signal on or off.
By default the signal is disabled. When enabled, a
TTL compatible square wave is output.
Syntax OUTPut[1|2]:TRIGger {OFF|ON}
Parameter OFF Turns the output off.
ON Turns the output on.
Example OUTP1:TRIG ON
Turns the output on.
Query Syntax OUTPut[1|2]:TRIGger?
Return Parameter 0 Disabled
1 Enabled
Query Example OUTP1:TRIG?
1