GW Instek AFG-3000 Series - Manual (Page 243)

REMOTE INTERFACE
243
SOURce[1]:FREQuency:STARt
Source Specific
Command
Description Sets the start frequency of the sweep. 100Hz is the
default start frequency.
Note To sweep up or down, set the stop frequency
higher or lower than the start frequency.
Syntax SOURce[1]:FREQuency:STARt
{<frequency>|MINimum|MAXimum}
Parameter <frequency> 100μHz~ 80MHz(3081)/
50MHz(3051)
100μHz~ 1MHz (Ramp)
Example SOUR1:FREQ:STAR +2.0000E+03
Sets the start frequency to 2kHz.
Query Syntax SOURce[1]:FREQuency:STARt? [MINimum|
MAXimum]
Return Parameter <NR3> Returns the start frequency
in Hz.
Example SOUR1:FREQ:STAR? MAX
+8.0000E+07
Returns the maximum start frequency allowed.
SOURce[1]:FREQuency:STOP
Source Specific
Command
Description Sets the stop frequency of the sweep. 1 kHz is the
default start frequency.
Note To sweep up or down, set the stop frequency
higher or lower than the start frequency.
Syntax SOURce[1]:FREQuency:STOP
{<frequency>|MINimum|MAXimum}
Parameter <frequency> 100μHz~ 80MHz(3081)/
50MHz(3051)
100μHz~ 1MHz (Ramp)