GW Instek AFG-3000 Series - Manual (Page 255)

REMOTE INTERFACE
255
Example SOUR1:BURS:NCYC?
+1.0000E+02
The burst cycles are set to 100.
SOURce[1]:BURSt:INTernal:PERiod
Source Specific
Command
Description Sets or queries the burst period. Burst period
settings are only applicable when the trigger is set
to immediate. The default burst period is 10 ms.
During manual triggering, external triggering or
Gate burst mode, the burst period settings are
ignored.
Note The burst period must be long enough to output
the designated number of cycles for a selected
frequency.
Burst period > burst count/(waveform frequency
+ 200 ns)
If the period is too short, it is automatically
increased so that a burst can be continuously
output. A “data out of range” error will also be
generated.
Syntax SOURce[1]:BURSt:INTernal:PERiod
{<seconds>|MINimum|MAXimum}
Parameter <seconds > 1 us ~ 500 seconds
Example SOUR1:BURS:INT:PER +1.0000E+01
Sets the period to 10 seconds.
Query Syntax SOURce[1]:BURSt:INTernal:PERiod?
[MINimum|MAXimum]
Return Parameter <NR3> Returns the burst period in seconds.
Example SOUR1:BURS:INT:PER?
+1.0000E+01
The burst period is 10 seconds.