GW Instek AFG-3000 Series - Manual (Page 252)

AFG-3000 Series User Manual
252
The following is an overview of the steps required to generate a
burst waveform.
Enable Burst
Mode
Configuration
Choose
Triggered/Gated
Mode
Set Burst Count
Set the burst
period
Set Burst Starting
Phase
Select the trigger
1. Turn on Burst mode using the
SOURce[1]:BURS:STAT ON command.
2. Use the APPLy command to select a sine,
square, ramp, pulse or triangle burst
waveform*. Alternatively, the FUNC, FREQ,
AMPl, and DCOffs commands can be used to
create the burst waveform* with a designated
frequency, amplitude and offset.
*2 mHz minimum for internally triggered
bursts.
3. Use the SOURce[1]: BURS:MODE command
to select from triggered or gated burst modes.
4. Use the SOURce[1]:BURS:NCYC command to
set the burst count. This command is only for
triggered burst mode only.
5. Use the SOURce[1]:BURS:INT:PER command
to set the burst period/cycle. This command
is only applicable for triggered burst mode
(internal trigger).
6. Use the SOURce[1]:BURS:PHAS command to
set the burst starting phase.
7. Use the SOURce[1]:BURS:TRIG:SOUR
command to select the trigger source for
triggered burst mode only.