HT instruments PVCHECK - Manual (Page 12)

PVCHECK
EN - 10
5.1.2. Measuring unit
This section allows setting the measuring units of some parameters included in the
database (DB) for the management of PV modules (see § 5.6) when measuring IVCK.
1. Position the cursor onto “Measuring Unit” by using the
arrow keys (
,) and confirm with ENTER.
2. The display shows the screen which allows setting the
measuring units of the following parameters:
 Alpha  possible selection: “%/°C” and “mA/°C”
 Beta  possible selection: “%/°C” and “mV/°C”
 Gamma  expressed in “%/°C”
 Voc and Isc tolerance  expressed in “%”
3. Set the desired measuring units by means of the arrow
keys (
 , ).
4. Press the SAVE key to save the settings made; the
message “Data saved” will be displayed for a few seconds.
5. Press the ESC/MENU key to exit without saving and go
back to the previous screen.
15/05/12 15:34:26
A l p h a :  m A / ° C 
B e t a
G a m m a
T o l e r a n c e
: % / ° C
: % / ° C
: %
S A V E t o s t o r e
S E T
5.1.3. Date and time
1. Position the cursor onto “Date and Time” by using the
arrow keys (
,) and confirm with ENTER.
2. The display shows the screen which allows setting the
system’s date/time both in the European (EU) or in the
USA (US) format.
3. Set the desired measuring units by means of the arrow
keys (
 , ).
4. Press the SAVE key to save the settings made; the
message “Data saved” will be displayed for a few
seconds. Press the ESC/MENU key to exit without saving
and go back to the previous screen.
15/05/12 15:34:26
Y e a r :  2 0 1 2 
M o n t h
D a y
H o u r s
M i n u t e s
F o r m a t
: 0 5
: 1 5
: 0 9
: 5 3
: E U
S A V E t o s t o r e
S E T