HT instruments PVCHECK - Manual (Page 57)

PVCHECK
EN - 55
7.3.2.1. Accessing the data saved in the memory – Numeric display
1. Select a line corresponding to a saved result and press
ENTER.
2. Select “Open” and press ENTER to open the section
where measurement results are displayed as:
 Numeric screens of measured parameters under
standard (STC) conditions and under operating
(OPC) conditions for IVCK tests
 Numeric screens of measured parameters when
measuring insulation (M
) and continuity (LOW).
15/05/12 15:34:26
MEM Comments
001 PV PLANT 1
002* PV PLANT 2
O p e n
R e c a l l 
D e l e t e 
Selection MEM-IVCK
3. For IVCK test, there are the values of the following
parameters:
 The module being used
 The value of irradiance
 The value of temperature of the module
 The average values of Voc and Isc under OPC
conditions
 The values of Voc and Isc measured under OPC
conditions
 The values of Voc and Isc calculated under STC and
the relevant partial results obtained by comparison with
the nominal values.
15/05/12 15:34:26
M o d u l e : S U N P W R 2 1 0

I r r 9 0 3 W / m 2
T c ( A U T O ) 5 7 ° C
V o c A v g @ O P C - - - V
I s c A v g @ O P C - - - A
V o c @ O P C 6 4 7 V
I s c @ O P C 5 . 3 5 A
V o c @ S T C 7 8 7 V O K
I s c @ S T C 5 . 7 2 A O K
Outcome: OK
Selection I V C K
4. For M
 test in FIELD mode there are the values of the
following parameters:
 Set rated test voltage
 Minimum threshold set on insulation measurement
 The type of mode·selected
 The real value of the applied test voltage
 The insulation value of positive pole Ri (+)
 The insulation value of positive pole Ri (-)
15/05/12 15:34:26
I n s . T e s t : 1 0 0 0 V
R i m i n : 1 . 0 M 
M o d e : F i e l d
V t e s t 1 0 6 5 1 0 6 4 V
R i ( + ) > 1 0 0 M

R i ( - ) > 1 0 0 M

R p 7 2 M

Outcome: OK
Selection M
 
5. For M
 test in TIMER mode there are the values of the
following parameters:
 Set rated test voltage
 Minimum threshold set on insulation measurement
 The type of selected mode
 The real value of the applied test voltage
 The Ri(+) minimum value of insulation resistance of
the PV module/string (or of other metal masses)
being tested, continuously measured during the
whole duration of measurement.
 The set measuring time
15/05/12 15:34:26
I n s . T e s t : 1 0 0 0 V
R i m i n : 1 . 0 M

M o d e : T i m e r
V t e s t 1 0 2 0 V
R i ( + ) m i n > 2 0 0 M

Test time: 10s
Oucome: OK
Selection M
 