Operation, 2 hardware settings – KROHNE H250 M40 FOUNDATION FIELDBUS User Manual
Page 12
Advertising
4
OPERATION
12
H250 M40
www.krohne.com
02/2014 - 4001208201 - AD H250 M40 FF R02 en
4.2 Hardware Settings
S1.7 - Simulation enable/disable
S1.8 - Write protection
S1.7 - Simulation enable/disable
S1.8 - Write protection
Unscrew housing cover
Remove small cover from FF board
Set switch block S1 switch 7 to desired position:
• DISABLE: up position (factory setting)
• ENABLE: down position
Put small cover on FF board
Screw on housing cover
Unscrew housing cover
Remove small cover from FF board
Set switch block S1 switch 8 to desired position:
• OFF: up position (factory setting)
• ON: down position
Put small cover on FF board
Screw on housing cover
AD_H250_M40_FF_R02_en_4001208201_PRT.book Page 12 Friday, February 21, 2014 11:25 AM
Advertising