KROHNE H250 M40 FOUNDATION FIELDBUS - Manual (Page 23)

OPERATION
4
23
H250 M40
www.krohne.com 02/2014 - 4001208201 - AD H250 M40 FF R02 en
RB_DIAG
RB
R reason for bits set at BLK_ERR and other diagnosis current diagnosis
Setting:
• Startup Device
• RB : MODE_BLK.ACTUAL is OOS
• Memory failure
• Operating System
• new : ID , DEV_TYPE , SNR
• no HART Communication
• Startup HART , data invalid
• Startup Sensor , data valid
• Device Type doesn’t match to FF Software
• Device Type changed
• ER doesn’t match to FF Software
• MODE_BLK.PERMITTED doesn’t include Auto
• MODE_BLK.TARGET is set OOS
• HART bold F message
• HART F message
• write from HART to RB/TB doesn’t work
• HART Mfr unknown
• HART serial number
• Boardinfo incomplete or corrupt
• action : write from HART to RB/TB
• HART W : no , M : no
• HART W : no , M : some
• HART W : some , M : no
• HART W : no , M : all
• HART W : all , M : no
• HART W : some , M : some
• HART W : some , M : all
• HART W : all , M : some
• HART Communication few loss
• RS_STATE is not On-Line
• simulation active
• SET_FSTATE was set
• unknown reason
• ok
Manufacturer specific parameters for Resource Block
Parameter Parameter Parameter Parameter
DD Name Access Description
Settings Initial
AD_H250_M40_FF_R02_en_4001208201_PRT.book Page 23 Friday, February 21, 2014 11:25 AM