KROHNE H250 M40 FOUNDATION FIELDBUS - Manual (Page 22)

4
OPERATION
22
H250 M40
www.krohne.com 02/2014 - 4001208201 - AD H250 M40 FF R02 en
4.5.2 Manufacturer specific parameters of the signal converter for Resource Block
Manufacturer specific parameters for Resource Block
Parameter Parameter Parameter Parameter
DD Name Access Description
Settings Initial
DEV_DESCRIPTION DEV_DESCRIPTION DEV_DESCRIPTION DEV_DESCRIPTION
device description
Describes some characteristics of the device.
SERIAL_NUMBER
Serial Number
R device serial number , serial number of the system current serial
number
PRODUCTION_ORDER
production order
R Production order for complete meter current production
order
ELECTRONIC_REV
electronic revision
R Electronic Revision of the device current electronic
revision
DIAGNOSIS DIAGNOSIS DIAGNOSIS DIAGNOSIS
Diagnosis
detailed diagnosis of the device.
MEMORY_SUMMARY
Memory Summery
R summary of self diagnosis. ok
Setting:
• ok
• bit8…15: not used
• EEPROM
• FRAM
• FLASH
• ROM application
• ROM boot area
• RAM ext
• RAM int
• Task Control
FRAM_DIAG
FRAM diagnosis
R Result of FRAM self diagnosis. ok
Setting:
• ok
• not supported action
• unknown
• busy
• wait
• first init
• changed
• bit09
• parameter error
• page error
• chip error
• write error
• warning: inconsistent
• warning: uncertain
• warning: write cycles
• warning: one header
• ok, page high
work_LOAD
work load
R Work load of the processor. current work load
DIAGNOSIS_BLK DIAGNOSIS_BLK DIAGNOSIS_BLK DIAGNOSIS_BLK
diagnosis block
detailed diagnosis of the blocks
AD_H250_M40_FF_R02_en_4001208201_PRT.book Page 22 Friday, February 21, 2014 11:25 AM