KROHNE H250 M40 FOUNDATION FIELDBUS - Manual (Page 26)

4
OPERATION
26
H250 M40
www.krohne.com 02/2014 - 4001208201 - AD H250 M40 FF R02 en
IT1_DIAG
IT1
R reason for OUT.status not Good , bits at BLK_ERR and other
diagnosis
current diagnosis
Setting:
• Startup Device
• RB : MODE_BLK.ACTUAL is OOS
• Memory failure
• no schedule
• period of execution
• period of execution to large
• MODE_BLK.PERMITTED doesn’t include Auto
• MODE_BLK.TARGET is set OOS
• MODE_BLK.TARGET is set MAN
• MODE_BLK.ACTUAL is MAN , Startup to Auto
• INTEG_TYPE is uninitialized
• IN_1 and IN_2 are not connected
• TIME_UNIT1 and TIME_UNIT2 are uninitialized
• CLOCK_PER <= period of execution
• TIME_UNIT1 is uninitialized
• TIME_UNIT2 is uninitialized
• IN_1.status is Bad
• IN_2.status is Bad
• IN_1.value is NaN or INF
• IN_2.value is NaN or INF
• PCT_INCL < UNCERT_LIM
• PCT_INCL < GOOD_LIM
• PULSE_VAL1 and PULSE_VAL2 are 0
• TOTAL_SP is 0 : cyclic reset
• unknown reason
• ok
DIAGNOSIS_DEV DIAGNOSIS_DEV DIAGNOSIS_DEV DIAGNOSIS_DEV
diagnosis device
Display of maximum 4 error messages.
diag_enum_dev
ESK diag
R Setting: current diagnosis
• Startup phase
• F Internal communication
• F ROM error
• F RAM error
• F Memory corrupted
• F Crystal failure
• F Invalid drift
• F Sensor A failure
• F Sensor B failure
• reserved 0.7
• S electronic temperature
• S PV > 100%
• S No pre-linearisation
• S No compensation
• S No output linearization
• reserved 1.6
• reserved 1.7
• reserved 2.0
• reserved 2.1
• reserved 2.2
• reserved 2.3
• reserved 2.4
• reserved 2.5
• reserved 2.6
• no message
ESK_DESCRIPTION ESK_DESCRIPTION ESK_DESCRIPTION ESK_DESCRIPTION
ESK description
ESK basic module description
FIRMWARE_VER_ESK
firmware version ESK
R Firmware version of ESK basic module current version
SERIAL_NUM_ESK
serial number ESK
R Serial number of ESK basis module current serial
number
Manufacturer specific parameters for Resource Block
Parameter Parameter Parameter Parameter
DD Name Access Description
Settings Initial
AD_H250_M40_FF_R02_en_4001208201_PRT.book Page 26 Friday, February 21, 2014 11:25 AM