Brother PT-9700PC - Manual (Page 10)

P-touch Template Command Reference.
⑨ Prefix character setting
Change the prefix character code. Specify as a one-character character code.
The prefix character is the code for the first character that identifies commands that can
be used in P-touch Template mode.
⑩ Non-printed character setting
The characters specified here are not printed when data is received. Specify 1 to 20
characters.
⑪ Line feed character setting
The line feed code is used when feeding data to indicate that the following data should
be moved to the next line in a text object. One of the following four line feed codes can
be selected, or 1 to 20 characters can be specified as the line feed code.
1. ^CR
2. \0D\0A
3. \0A
4. \0D
⑫ FNC1 replacement setting
This setting selects whether or not GS codes, which are included in bar code protocols
such as GS1-128 (UCC/EAN-128), are replaced with FNC1 codes.
If the check box is selected, a received GS code is replaced with the FNC1 code. If the
check box is cleared, a received GS code is outputted as is.
⑬ Number of copies setting
Specify the number of copies. A number between 1 and 99 can be specified.